RADEMACHER DuoFern Installation And Commissioning Manual page 19

i
9.4 Teaching in the window or door positions
1.
Open the window or door.
2.
Activate the desired mode:
3 sec. = Window mode >
S
2 x
3.a
Close the window or door.
2 x
The following point 3.b is skipped in door mode!
Additionally in window mode (green LED)
3.b
Tilt the window.
2 x
4.
Open the window or door again.
2 seconds
The teach-in process is completed at this point.
6 sec. = Door mode >
9 sec. = Inverted door mode > LED flashes red
Then two short acoustic signals
confirm that the first position is stored.
After approx. 3 seconds, two short
acoustic signals confirm that this
position is stored.
After approx. 3 seconds, two short
acoustic signals confirm that this
position is stored.
A long acoustic signal confirms the
successful teach-in process and the
LED goes off.
LED flashes green
LED flashes blue
EN
19