Teaching In The Window Or Door Positions - RADEMACHER DuoFern Installation And Commissioning Manual

i

9.4 Teaching in the window or door positions

The DuoFern Window/Door Contact has three operating
modes. The teach-in processes are carried out in the re-
spective mode:
◆ Window mode (open / closed / tilted), LED flashes green
◆ Door mode (open / closed), LED flashes blue
◆ Inverted door mode (open = closed / closed = open),
LED flashes red
i
Time limit for the teach-in process
The teach-in process is active for 60 seconds after
activating a mode.
Cancelling the teach-in process
S
Pay attention to the acoustic feedback signal
An acoustic feedback signal is given during the teach-in
process. If an acoustic feedback signal is not given, this
is an indication that the distance between the magnet and
sensor was too large or ferrous material or other magnets
do not enable a reliable differentiation between the states.
18
Start each teach-in process with the window or
door open. This is also required each time the
operating mode is changed.
You can cancel the teach-in process
by pressing the set button.
EN