Table of Contents
Advertisement
Cleaning and care
2. Cleaning intervals for the plinth fil-
ter
The filter (in the plinth) is located behind
the fluff filter flap on the bottom left.
With normal use
Clean when
Clean airways
the display.
With continuous use
Clean once daily and additionally
when the prompt appears in the dis-
play.
The surface of the filter in the filter in-
sert is visible after removing the fluff
filter. This filter surface must also be
cleaned.
To clear the message: Touch the
OK
sensor.
52
appears in
Damage caused by insufficient
cleaning or by operation with a worn,
damaged filter in the plinth.
There is insufficient flow of air and
heat in the heat exchanger due to
clogging. This requires a visit from
the Service department.
This can be avoided by following the
advice in these operating instruc-
tions.
Advertisement
Table of Contents
