Table of Contents
Advertisement
Message
Clean fluff filter.
Check the air-
ways.
continues
to light up after a
programme has
been cancelled,
despite thorough
cleaning.
Check water drain-
age
lights up after a
programme has
been cancelled.
Plinth filter not fitted.
Please fit it.
Fault F. If restart
fails, call Service
lights up after a
programme has
been cancelled.
Obstruction detec-
ted. Untangle laun-
dry and restart
lights up after a
programme has
been cancelled.
Finish/Cooling down
up and the drying pro-
gramme is not yet com-
plete.
Cause and remedy
The plinth filter looks clean after thorough cleaning.
However, the programme terminates and the error
message appears again. It is likely that there is still
underlying residue that could not be removed.
To delete the message: Touch the
trol.
Replace the plinth filter with a new one.
You can reactivate the removed, "old" plinth filter
in the washing machine. Follow the instructions
described in "Problem solving guide – Reactivating
the plinth filter".
There is a fault in the condensate drainage.
Check that the drain hose is correctly fitted and is
not kinked.
To clear the message: Open and close the door
with the tumble dryer switched on.
The plinth filter is missing.
Check the filter (in the plinth).
Removing the filter during a drying programme will
result in the cancellation of the programme.
There is no obvious cause.
Note the message on the display.
Touch the
If the programme terminates again with the same er-
ror message, then there is a fault. Contact Miele Ser-
vice.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. Take out
some of the laundry if necessary.
Close the door.
Start a programme.
lights
This is not a fault. The laundry will be cooled further.
The programme is almost complete.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down.
Problem solving guide
OK
sensor.
OK
sensor con-
69
Advertisement
Table of Contents
