Installation; Mounting - ProLights ECLFR2KTW User Manual

Fresnel projector

Table of Contents

Available languages

- 2 - INSTALLATION

ECLFR2KTW is designed for applications in exhibition areas, commercial spaces, museums, restaurant,

churches, and any other installation where size is an important factor. For fixing, stable mounting clips are

required. The mounting place must be of sufficient stability and be able to support a weight of 10 times

of the unit's weight.

When carrying out any installation, always comply scrupulously with all the regulations (particularly re-

garding safety) currently in force in the country in which the fixture's being used.

• Install the projector at a suitable location.

• Always additionally secure the projector with the safety rope from falling down. For this purpose, fas-

ten the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm. The

adjust the projector and use the knobs.

NOTE - For the installation of the ECLFR2KTW make sure that the ridge of the adaptor is in with the groove

of the track. Turn knobs 90° to connect the adaptor to the circuit. Please see the figure 4.

ECLFR2KTW

CLAMP

Fig.4

Table of Contents

Table of Contents