Information; Master/Slave Mode; Effects Mode - ProLights ECLFR2KTW User Manual

12
maxinum value of the colors) or Studio mode with a automatic white balance.
- Dimmer Mode - Adjusting the dimmer. Enter in Dimmer Mode to select specific dimming curve.
Particularly when set:
• Off: The increase in light intensity is linear.
• Dimmer 1: dimmer curve with low fade.
• Dimmer 2: dimmer curve with medium fade.
• Dimmer 3: dimmer curve with high fade.
- White Balance - To balance the white on each color. Select the color (Red, Orange, Green, Royal Blue, Blue
and Lime) and the value (125-255) using the UP / DOWN button and press the ENTER button to confirm.
- LED Frequency - To adjust the frequency of the LEDs. Select the frequency 600 Hz - 25 KHz using the UP /
DOWN button and press ENTER to confirm the selection.
- Fan Mode - Fan Speed. Select the fan speed (Auto, On, Off, Silent) using the UP / DOWN button.
- Factory Reload - To reset the unit. Select Yes or No and select the UP / DOWN button to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.9 INFORMATION

To view all the information on the device, proceed as follows:
• Press the button MENU to enter the menu mode.
• Press UP/DOWN button to select Information, then press the ENTER button to access the next menu.
• Press UP/DOWN button to scroll through the menu, then select one of the following informationa and
press the ENTER button to display it.
- Fixture Time - To view the operating time of the projector.
- Software Version - To view the firmware version will show on the display.
- UID - To view the identification ID for the RDM control.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.10 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Press the button MENU so many times until the display shows Stand Alone, then press the ENTER button
to select Master/Slave.
• Press UP/DOWN button to select the desired mode and then press ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
• Set the slaves to the same DMX modes.
NOTE: the unit, set in Static or Effect mode, always appears to be Master.

3.11 EFFECTS MODE

This fixture has a built-in automatic program. To access this, please see the below instructions:
• To enter the Effects mode, press the ENTER button to access the menu.
• Press UP/DOWN button to select Stand Alone, then select Effect. Press ENTER to confirm
• Press UP/DOWN button to select the desired program Effect 1, Effect 2, Effect 3, Effect 4, then press ENTER
to confirm.
• Set the value (1 - 100), then press the ENTER button to confirm.
NOTE: after selecting the described mode, the unit will be Master.
ECLFR2KTW