Table of contents Table of contents About these instructions for use Target groups Labelling of notes About this translated version Product information Standards and regulations Intended use 2.2.1 Areas of use 2.2.2 Media 2.2.3 Drainage capacity Product description 2.3.1 Overview 2.3.2 Technical data Information for use...
This restriction does not extend to possible operating instructions. The installation of Viega products must take place in accordance with the general rules of engineering and the Viega instructions for use.
About these instructions for use About this translated version This instruction for use contains important information about the choice of product or system, assembly and commissioning as well as intended use and, if required, maintenance measures. The information about the products, their properties and application technology are based on the current standards in Europe (e.
2 Product information Standards and regulations The following standards and regulations apply to Germany / Europe. National regulations can be found on the relevant web site of your viega.com/standards . country at Regulations from section: Media Scope / Notice Regulations applicable in Ger-...
Product information 2.2.3 Drainage capacity Nominal width [DN] (drain socket) Drainage capacity at an accumu- 1.6 l/s lation height of 20 mm above the grate The values are dependent on the total height of the drain unit. Product description 2.3.1 Overview Fig.
Product information 2.3.2 Technical data Nominal width [DN] (drain socket) Nominal width [DN] 50 or 70 (only in connection with connecting (inlet) piece model 4997) Drainage capacity Ä Chapter 2.2.3 „Drainage capacity“ on page 7 Water head seal 50 mm Dimensions and Ä...
Handling 3 Handling Assembly information 3.1.1 Important note Before assembly: Check if the drainage capacity of the drain is sufficient for the arising Ä Chapter 2.2.3 „Drainage capacity“ on page 7 . water volume Check if the installation height of the drain corresponds with the planned floor construction.
Handling 3.1.3 Tools and materials Required material Material for securing the drain For the mounting of the connecting piece (optional): compass saw Assembly 3.2.1 Connecting the drain Connecting to the wastewater system The connection to the wastewater system must be completed before the drain can be installed in the floor construction.
Handling Secure the drain in such a way that it cannot shift when the subse- quent works are applied. Most importantly, it must be ensured that the drain does not float when the concrete or screed is poured in. Work the drain into the screed or floor covering. NOTICE! Product damage due to improper installation If hollow spaces occur during the lining of the drain, leaks...
Handling Clean drain. Re-insert grate. Disposal Separate the product and packaging materials (e. g. paper, metal, plastic or non-ferrous metals) and dispose of in accordance with valid national legal requirements. Kellermeister cellar drain 12 from 12...