Advertisement
Regular Maintenance...
If you require further training or
Index page...
assistance contact your supervisor
Removing the Battery ...
A
B
C
Unplug the battery from the machine using the red connection handle (Fig.A & B).
The battery can then be lifted from the machine for storage or charging (Fig.C).
Removing the Battery Pack Fuse ...
The battery pack comes fitted with a 40 amp safety fuse.
Replace the fuse using (208526) Numatic approved part
Battery Charging ...
Recharge the machine fully after its last use. Do not leave the machine in a discharged state.
Under abnormal use; i.e. leaving the machine without charging for a period of time, we advise that you disconnect the battery from the machine.
If the machine will be standing unused for a period of 30 days or more, then batteries must be fully charged.
Note: Batteries should be recharged every three months. Charge fully the day before you start using the machine again.
Under normal daily usage:
Recharge batteries after each use regardless of machine operation time. Connect the charger unit to the battery and plug the charger into a suitable power
supply.
Fitting Brush - Floor Tool, Filling Machine, Fill Gauge, Moving
Water Flow Adjustment, Raising the Floor Tool
Operating Switches
Draining Top Tank, Draining Bottom Tank, Clean Water Filter
Clean Separator
Changing the Floor Tool Blades
Removing Battery, Fuse, Charging
Charging (Cont)
Advertisement
