Table of Contents
Advertisement
2.3.5 PoE (Power over Ethernet) Ports
PoE+
PoE+
3
4
5
LAN 3
LAN 5
LAN 4
LAN 6
There are 4 RJ45 connectors in the rear side of ECS-9000. It supports IEEE
+
802.3at (PoE
) Power over Ethernet (PoE) connection delivering up to 37W/
54V per port and 1000BASE-T GigE data signals over standard Ethernet Cat
5/Cat 6 cable. Each PoE connection is powered by Intel
controller and independent PCI express interface to connect with multi-core
processor for network and data transmit optimization. Only when PoE port starts
to supply power to power devices, the dedicated LED will be lightened.
PS. Suggest to use PoE function when power input is over 12V.
The pin-outs of LAN 1 and LAN 2 are listed as follows:
Pin No.
10/100 Mbps
1
2
3
4
5
6
7
8
Each LAN port is supported by standard RJ-45 connector with LED indicators to
present Active/Link/Speed status of the connection.
The LED indicator on the right bottom corner lightens in solid green when the
cable is properly connected to a 100Mbps Ethernet network; The LED indicator
on the right bottom corner lightens in solid orange when the cable is properly
connected to a 1000Mbps Ethernet network; The left LED will keep twinkling/ off
when Ethernet data packets are being transmitted/received.
LED Status
10Mbps
Right
Off
Bottom Led
Left
Flash
Bottom Led
Yellow
COM 1
COM 3
6
COM 2
COM 4
E_TX+
E_TX-
E_RX+
----
-----
E_RX-
-----
------
100Mbps
Solid
Green
Flash
Yellow
DIO
Isolated
20
11
10
1
PIN 1 ~ 8
D I
PIN 11 ~ 18
DO
®
I210 GigE Ethernet
1000Mbps
MDI0_P
MDI0_N
MDI1_P
MDI2_P
MDI2_N
MDI1_N
MDI3_P
MDI3_N
1000Mbps
Solid
Orange
Flash
Yellow
GETTING TO KNOW YOUR ECS-9000
DC-IN
IGN
On / Off
Power Switch
PoE
PoE+
PoE+
PoE-
----
----
PoE-
----
----
1
8
43
Advertisement
Table of Contents
