Electrical Controls - Promac FX-820VA Manual

Controls

Electrical Controls

Stop switch (A, Fig.11)
The switch is a power switch with emergency stop
function.
The green button starts the machine with the red
button the machine is stopped.
The red emergency button which can be used,
when problems occured.
Speed selector (B, Fig. 11)
Using the speed selector switch to change the motor
speed infinitely. The switch must be switched off
before the machine can be set to "0".
Speed display (C, Fig.1
The set speed can be read on the display.
Drilling depth indicator (D, Fig. 11)
1. To turn on the digital depth indicator, press the
"ON" button to set the display to "0".
2. With key can set the desired depth .
3. After setting the depth use the right head fine
feed switch (K, Fig. 12).
4. With the lever (M, Fig. 12) to start feed, until the
desired depth is reached.
5. If the depth setting is too low, use the correct
key to adjust depth.
NOTICE. kpress key mm / in displaying to change
metric and inch (inch) unit.
The digital display is a battery type SR44W,
1.55 V operated.
To replace, follow the instructions on the
following pictures:
Fuse (D, Fig. 13)
The electrical system on the machine side has a 10A
fuse.
) 1
D
C
A
B
Fig. 11
M
Fig. 12
Fig. 13
J
L
K