Installation Of The Machine - Promac FX-820VA Manual

Installation of the machine

The minimum requirements for installation of the machine are:
- Mains voltage and frequency correspond to the characteristics of the motor of the machine.
- Ambient temperature from - 10 ° C to + 50 ° C.
- Relative humidity not more than 90%.
Anchoring of the machine
The machine is on a solid surface in a
Minimum distance of 800mm to the back wall
set up and by means of screws and expansion plugs
or walled rods in the ground
anchor. It is important to pay attention to the leveling.
1. Disassemble the crank mounted head and
imagewise handle 2, A + B.
2. 3 cranks up the table.
Assembly of the machine (Fig.03)
1. Assemble the machine on the stand (option) or
worktable.
2. Set the machine at a uniform temperature place.
Make sure that the site the machine is not exposed
under the sun. Otherwise there is a risk of unstable
accuracy.
3. Check that the motor rotates clockwise before the
final connection of a plug to the external pwoer.
4. Provide the machine base on a level concrete base.
5. The machine has foot hole slots for the mounting
screws. Before tightening the screws please
consider whether the work table in the longitudinal
and Transversely with respect to the circumferential
working spindle are aligned. Use fine-gauge with
1/1000 with the corresponding reading scale
measure the spindle and align the table.
If necessary use appropriate foil sheets with
appropriate thickness (spy plate) between the
mounting plane and the machine foot to settle.
Cleaning and lubrication of the new machine
The uncoated surfaces of the machine is preotected with a viscous grease against corrosion for transport.
This must, before the machine is put into operation, be completely removed. This is either petroleum
washing or use petrol.
Note: Do not use paint thinner or similar since it will destroys the painting of the machine.
Make sure that get no solvents or grease on rubber and plastic parts.
Coat all unpainted parts of the machine with a thin layer of oil. PROMAC Art. 100385 (sold Switzerland only)
B
A
Fig. 02
Fig. 03