Promac FX-820VA Manual page 34

Controls
Longitudinal movement of the table
(A, Fig. 04)
On each side of the table are the cranks
to move the table longitudinally.
Transverse movement of the table
(B, Fig. 04)
The front of the table is for the crank transverse
displacement of the table.
Fig. 04
Adjustment crank head (C, Fig. 05)
Is on the right side of the column. By turning the
crank, the head moves to the desired working height.
Turn clockwise to raise - turn counter-clockwise to lower.
Once good position, stop the head with the plastic
C
knobs.
Fig. 05
Stops table (D, Fig. 06)
The stops limit longitudinal travel (D) are
in front of the work table.
Handles lock table (E and F, Fig. 06)
Locking of the table for the longitudinal stroke
the handles (E) lie in front of the table.
Locking the handles (F) for the transverse stroke
are right lower corner of the table.
Fig. 06
Handles lock head (G, Fig. 07)
This is located on the right side of the drill head.
Spindle clamp handle (H, Fig. 07)
The spindle clamp handle is located at the left side of
the drill head. After the adjusting spindle drilling depth
it can be secured with the clamping handle.
NOTE
For best results, when drilling or
H
Milling ,tightened all the necessary clamping handles
G
to minimize contact vibrations.
Fig. 07