Securing Firebox To Wall Using Fixing Brackets; Completing The Fan Box Installation - Baxi GALLERY Series Installer's Manual

INSTALLER GUIDE

8.3 Securing firebox to wall using fixing brackets.

See section 9.1 'Gas supply connection'.
1. Loose assemble the two fixing brackets provided (See
figure 23) using the screws provided.
2. Offer fire up to wall.
3. Establish the final location of firebox, and secure fixing
brackets accordingly.
4. Mark off the wall, drill two holes using no.10 drill bit.
Insert wall plugs.
5. Secure using wood screws provided.

8.4 Completing the fan box installation.

1. Offer the fan box to
the wall. Locate the fan
box spigot into the flue
and secure the fan box
Figure 23.
to the wall using the
screws supplied. Be
careful not to trap or
damage the wiring
loom.
2. Make good around
Figure 24.
the fan box, ensuring
that no gaps appear
between the box and wall.
3. Stow the excess cable as shown in figure 24. Leave
about 200mm of free length for fan motor connection.
Secure the stowed cable inside the fan box with cable
ties.
4. Replace the fan unit taking care not to snag or
otherwise damage the electrical fitments. Connect the
cable loom to the fan unit (See figure 25)
5. Upon completion of cable installation ensure that
Figure 25.
the loom and cables do not touch the horizontal
surface of the fan casing immediately above the
rectangular flue gas outlet. If cables run close or are in contact with this surface they
should be held clear using the additional cable ties provided.
6. Upon completion ensure a neat and tidy installation before replacing the fan box
cover .
7. Replace the fan box cover and weather shield (See figure 26) and secure using the
two screws provided.
Page 25