Baxi GALLERY Series Installer's Manual page 34

14.2 To remove the pilot unit.
1. Remove the complete burner module (See
section 14.1).
2. Disconnect the electrode lead from
underneath the electrode. To do this firmly hold
the electrode lead and gentle pull the lead clear
of the electrode.
3. Remove the thermocouple 'push on'
connector to the gas valve. To do this, firmly
hold the thermocouple connector and gently
pull it clear of the gas valve (See figure 36).
Never hold the thermocouple wire when
pulling.
4. Detach the pilot pipe from the pilot unit.
5. Remove the two screws securing the pilot unit
to the burner (See figure 37).
6. Remove the pilot unit and place it aside.
7. Refit in the reverse order. Make sure no leads
are trapped.
Note 1. The pilot unit must be replaced as a whole
assembly. Its individual components are not
separately replaceable.
14.3 To remove the burner from the burner
module.
(See figure 38).
1. Remove the complete burner module (See section
14.1).
2. Support the elbow injector and unscrew the
injector nut.
3. Remove the two screws from the burner clamping
plate (See figure 38)
4. Lift the right hand side of the burner, slide it to the
right and lift clear
5. Refit in reverse order.
INSTALLER GUIDE
Page 34
Figure 36. Removing the
thermocouple from the gas valve.
Figure 37. Pilot unit removal
Figure 38. Removal of burner