Cleaning Your Fire; Metal Parts; Ceramic Fuel Effect And Burner Compartment Rear Wall - Baxi 661 Owner's Manual

does not clear the flue, the pressure detector will
shut off the gas supply. The small light on the
control box will light each time the 'boost' speed
is used.
If the flames go out, or if for any reason the
!
fire is turned off, always wait at least 3
minutes before attempting to relight.
If this device starts to shut off the gas
!
frequently please get expert advice
This device is NOT a substitute for an
!
independently mounted Carbon Monoxide
detector.
To maintain the high performance and quality finish of your fire, please follow these
guidelines:
Before attempting to clean the fire, please remember to turn off the gas at the fire and
the electricity at the isolating switch.
Wait for the appliance to cool. The fire will retain heat for some time before cleaning
can begin.

Metal parts.

Clean the metal parts with a slightly damp cloth and then dry.
!
Do not use abrasive cleaners, as these will scratch the fire surface.
!

Ceramic fuel effect and burner compartment rear wall.

This product uses fuel effect pieces and a burner compartment rear wall
containing Refractory Ceramic Fibres (RCF), which are man-made vitreous
silicate fibres. Excessive exposure to this material may cause irritation to eyes, skin
and respiratory tract. Consequently, it is important to take care when handling
these articles to ensure that the release of dust is kept to a minimum.
Light coatings of soot will usually be burnt off during the normal operation of the
fire. Should any soot accumulation become excessive, the fuel effect pieces and
walls should be removed from the fire for cleaning. Cleaning should be carried out
in a well ventilated area or in the open air by gently brushing with the pieces held
away from your face so that you avoid inhaling the dust. We do not recommend the
use of a normal domestic vacuum cleaner which may blow dust back into the air.
We suggest that you remove the ceramic fuel effect in the reverse order to that
shown in the ceramic fuel effect installer and owner guide. This should have been
OWNER GUIDE

CLEANING YOUR FIRE

Page 8
Figure 2. Lighting with a taper (The
ceramic fuel effect may differ from
that shown)