Baxi GALLERY Series Installer's Manual page 33

Protective clothing is not required when handling these articles, but we recommend
you follow the normal hygiene rules of not smoking, eating or drinking in the work
area and always wash your hands before eating or drinking.
Check that the appliance is clean and that soot or debris is not blocking the gaps
!
between the ceramic fuel effect pieces causing an imperfect flame.
Check that soot or debris is not impairing the electrode spark or pilot burner.
!
Check that soot or debris is not blocking any of the slots / holes in the main burner.
!
Remove any lint from the components.
!
After servicing, make sure that the ceramic fuel effect pieces are replaced correctly
!
as described in the installer and owner guide supplied with the ceramic fuel effect.
The installer and owner guide supplied with the ceramic fuel effect should have
been placed inside or attached to this guide by the installer.
Always test for gas soundness and spillage after servicing the appliance and check
!
operation of all controls. (Do not use leak detection sprays on this appliance.
Sprays may affect the operation of electrical components. Keep all liquid detection
fluids clear of electrical components).
14.1 To remove the complete burner module.
1. Remove the ceramic fuel effect and
place carefully aside. The ceramic fuel
effect pieces can discolour decorative
surfaces. It is therefore advisable to
protect decorative surfaces.
2. Support the inlet 'T' connector to
avoid straining the pipework and
disconnect the appliance.
3. Remove the two burner securing
screws (See figure 34).
4. The solenoid valve leads are connected
to the control box under the burner
module. Carefully lift the burner unit out
from the hotbox and place immediately in
front of the hotbox. Do not attempt to lift
the burner
module away from the front of the firebox
as this may damage the solenoid leads.
5. Disconnect the solenoid leads from the
control box (See figure 35).
INSTALLER GUIDE
Figure 34. Burner securing screws
Figure 35. Removing the solenoid
leads from the control box.
Page 33