Operation; Battery Replacement - FireAngel ST-625 User Manual

4. Test Your FireAngel Smoke Alarm
After fitting your alarm to the base plate, wait
for 5 seconds for the alarm to settle then test
the alarm See 'Alarm Test'

OPERATION

Normal condition
The red LED on the front should flash every
45 seconds to show that the alarm is active
Low Battery Condition
Should your FireAngel smoke alarm enter a
low battery condition, the unit will emit an
audible 'chirp' once every 40 seconds When
this occurs, we recommend you replace the
batteries immediately Your FireAngel smoke
alarm will continue to warn of this low battery
8
condition for at least 30 days, however, failure
to change the batteries after this time will
mean your smoke alarm may have insufficient
power to alert you in a real fire situation.
When the batteries are removed the battery
warning chirp should stop
Sleep Easy™ - Low Battery Warning Silence
This feature can temporarily silence the low
battery chirp for 8 hours which is particularly
useful if the warning begins during the night
This feature may be repeated up to 10 times,
but is not a substitute for replacing the smoke
alarm batteries

BATTERY REPLACEMENT

IMPORTANT: Only the following batteries
can be used for replacement Use of a battery
other than those recommended below may
have a detrimental effect on the alarm's
operation
Alkaline type:
Energizer E91
Duracell MN1500bB
Panasonic ProPower LR6
Remove the alarm from its base plate by
turning anti-clockwise and pulling gently