Fit Your Smoke Alarm; Test Your Smoke Alarm; Operation; Normal Condition - FireAngel SI-601 User Manual

NOTE: On rare occasions the alarm may
sound when the battery is first installed.
If this happens, see Troubleshooting on
page 16.
The backing plate has a safety mechanism
which prevents the alarm being installed
without a battery. When the battery is
inserted this safety mechanism is released
meaning that the alarm can be attached to the
backing plate.
4 Fit Your FireAngel Smoke Alarm
The alarm will only lock into place in one
particular position. Position the smoke alarm
over the mounting plate lining up the central
vent on the front of the alarm with the 'X'
moulded into the plastic on the mounting
plate and turn clockwise. After one quarter
turn you should feel the alarm click into
place.
5 Test Your FireAngel Smoke Alarm
See 'Alarm Test' on page 11.

OPERATION

Normal condition
The red LED on the front should flash once
every 40 seconds to show the alarm is active.
Low Battery Condition
IMPORTANT: Your smoke alarm requires
a battery with a sufficient capacity of
power to operate correctly, this must also be
correctly installed.
Should your FireAngel smoke alarm enter a
low battery condition, the unit will emit an
audible 'chirp' once every 40 seconds. When
this occurs you must replace the battery
immediately. Your FireAngel smoke alarm
will continue to warn of this low battery
condition for at least 7 days, however, failure
to change the battery after this time would
mean your smoke alarm has insufficient
power to alert you in a real fire situation.
9