Fire; Si 601 Smoke Alarm Operation - FireAngel SI 601 User Manual

FI R E AND F IR E AL ARM

Fire

Important: Your attention is drawn to the
notice affixed inside the caravan wardrobe
advising on fire precaution, ventilation and
what to do in case of fire.
In case of fire
1. Get everyone out of the caravan as quickly
as possible using whichever exit is the
quickest, including windows. Do not stop to
collect any personal items.
2. Raise the Alarm. Call the Fire Brigade.
3. Turn off the gas supply valve if it is safe to
do so.
4. Turn off the electricity supply at
supply point.
Model-si 601 smoke
alarm operation
Normal condition
The red LED on the front should flash once
every 40 seconds to show the alarm is active.
Low Battery Condition
Important: Your smoke alarm requires a
battery with a sufficient capacity of power to
operate correctly. This must also be correctly
installed.
Should your smoke alarm enter a low battery
condition, the unit will emit an audible 'chirp'
once every 40 seconds. When this occurs you
must replace the battery immediately. Your
smoke alarm will continue to warn of this low
battery condition for at least 7 days, however,
failure to change the battery after this time
would mean your smoke alarm has insufficient
power to alert you in a real fire situation.
Battery replacement
Important: Only the following batteries can be
used for replacement. Use of a battery other
than those recommended below may have a
detrimental effect on the detector's operation.
Use of a lithium (long-life) battery could provide
power for 10 years under normal operating
conditions, meaning there is no need for an
annual battery change.
36
Note: The alarm cover can't be installed
without a battery fitted.
Note: Upon delivery the battery may be
fitted with a protective cover. Please ensure
this is removed before use.
Carbon-Zinc type:
Eveready Energizer 1222;
Gold Peak 16045 (UL).
Alkaline Type:
Energizer 522; Duracell MN 1604; Duracell 9V
Ultra; Energizer 9V Ultra+; Gold Peak 1604A.
Lithium (long life) type:
Ultralife U9VL
1. Remove the alarm from its mounting plate
by turning anti-clockwise
2. Remove the existing battery and replace
with a new battery. From the list above,
making sure that the positive and negative
connections are in the correct position. If
unsure see the alarm user manual.