Table of Contents
Advertisement
4.
Test
Your
Alarm
After fitting your alarm to the base
plate,
wait
for
alarm to settle then test the alarm
'Alarm Test'
OPERATION
Normal condition
The red LED on the front should flash
every 40 seconds to show that the alarm
is active
Low Battery Condition
Should your FireAngel
a low battery condition, the unit will emit
an audible 'chirp' once every 40 seconds
When this occurs, we recommend you
replace the batteries immediately Your
FireAngel
smoke alarm will continue to
Ⓡ
warn of this low battery condition for at
least 7 days, however, failure to change
the batteries after this time will mean your
smoke alarm may have insufficient power
to alert you in a real fire situation When
the batteries are removed the battery
warning chirp should stop
Sleep Easy™ - Low Battery Warning
Silence
This feature can temporarily silence the
low battery chirp for 8 hours which is
particularly useful if the warning begins
during the night
repeated up to 10 times, but is not a
substitute for replacing the smoke alarm
batteries (see page 11)
8
FireAngel
Smoke
Ⓡ
5
seconds
for
smoke alarm enter
Ⓡ
This feature may be
REPLACEMENT
the
IMPORTANT: Only the following batteries
See
can be used for replacement Use of a
battery other than those recommended
below may have a detrimental effect on
the alarm's operation
Alkaline type:
Energizer E91
Duracell MN1500bB
Panasonic ProPower LR6
Remove the alarm from its base plate by
turning anti-clockwise and pulling gently
BATTERY
Advertisement
Table of Contents
