Roller-Brush Assembly; Weight - Toro Reelmaster 03657 Installation Instructions Manual

Installing the Weights
Install the weights to the cutting units as shown in
Figure 4 .
1. Carriage bolts (5/16 x 1
inch)
2. Flange nuts (5/16 inch),
torque to 20 to 26 N∙m (15
to 19 ft-lb)
Figure 4

3. Weight

Installing the Roller-Brush
Assembly
1. Remove the 2 flange locknuts securing each
roller bracket to the side plates, as well as any
6 mm (1/4 inch) spacers positioned on the
top side of the side-plate mounting flange
(Figure 3).
Note:
Do not remove the bolts. Keep the flange
locknuts for future assembly.
2. Position the left or right roller-brush-assembly
mounting brackets onto the roller-bracket bolts
(Figure 5).
g283859
1. Left roller-brush assembly
Important:
for the roller-brush assembly directly to
the top surface of the side-plate mounting
flange of the cutting unit. Do not put spacers
3
Figure 5
2. Roller-brush mounting
bracket
Attach the mounting brackets
g033296