Toro Reelmaster 03657 Installation Instructions Manual page 2

Determining the
Roller-Brush Orientation
All cutting units are shipped with the counterweight
mounted to the left end of the cutting unit. Refer to
Figure 1 to determine the position of the roller brush
and reel motors.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
Note:
These instructions and illustrations show the
installation of the kit on cutting units with the universal
groomer mounted on the left end of the cutting unit.
Figure 1
5. Cutting unit 5
6. Reel motor
7. Right roller-brush drive
assembly
8. Left roller-brush drive
assembly
Installing the Kit
Installing the Grease Fitting
1. Remove the grease fitting for the roller from the
side of the cutting unit that has the roller-brush
housing (Figure
g027187
1. Grease fitting
2. Install the 90-degree grease fitting so that it
faces rearward
1. 6 mm (1/4 inch) spacer
2. Side-plate mounting flange 4. Flange locknuts (remove)
2
3).
Figure 2
(Figure 2).
Figure 3
3. 90-degree grease fitting
g032170
g032171