Table of Contents
Advertisement
Installing the Drive Pulley
1.
Restrain the reel before installing the drive
pulley; refer to
Restraining the Reel for Installing
Threaded Inserts (page
2.
Install the drive pulley onto the groomer shaft
(Figure
11).
1. Drive pulley
3.
Apply 242 Loctite (blue) to the hex-drive bolt
and use the bolt to secure the pulley to the
driveshaft; refer to
Note:
Torque the bolt to 20 to 26 N∙m (15 to
19 ft-lb).
Important:
If you do not properly torque the
bolt, the bolt will come loose.
13).
Figure 11
2. Hex-drive bolt—torque to
20 to 26 N∙m (15 to 19
ft-lb)
Figure
11.
Installing the Belt
1.
Install the belt onto the pulleys as follows:
•
Loop the belt around the drive pulley and
then over the top of the idler pulley
12).
1. Drive pulley
g033204
2. Idler-pulley assembly
•
Start the belt on the driven pulley
13).
•
Use a 9/16-inch deep-well socket to rotate
the brush assembly and guide the belt onto
the driven pulley
1. Belt
Important:
are properly seated in the grooves in each
pulley and that the belt is in the center of the
idler pulley.
6
Figure 12
3. Belt
4. Driven pulley
(Figure
13).
Figure 13
2. 9/16-inch deep-well socket
Ensure that the ribs on the belt
(Figure
g033205
(Figure
g033206
Advertisement
Table of Contents
