Toro Reelmaster 03657 Installation Instructions Manual page 5

A. Loosen the 2 flange locknuts securing
the roller-brush mounting bracket to the
cutting-unit side plate
B. Rotate the roller-brush-bearing housing until
the brush plate is parallel to the cutting-unit
side plate (Figure
C. Tighten the 2 flange locknuts securing
the roller-brush mounting bracket to the
cutting-unit side plate
Figure 9
1. Loosen these bolts for positioning the roller brush.
2. Loosen these nuts for making the roller-brush plate parallel.
(Figure 9).
9).
(Figure 9).
g033203
Positioning the Roller Brush
1. Loosen the 2 bolts securing each
roller-brush-bearing housing to the roller-brush
mounting bracket
Note:
The bolts should be loose from the
factory.
2. Position the roller brush so that it is just touching
or resting on the rear roller
Important:
The roller-brush shaft must not
contact the cutting-unit side plate.
Important:
Heavy brush contact on the
roller causes premature brush wear.
1. Bearing housing (some
parts not shown)
2. Side plate
3. Roller brush
4. Ensure that there is
clearance here.
Note:
The roller-brush shaft must be parallel
to the rear roller.
Important:
Position both
roller-brush-bearing housings so that
they are parallel to the ground to ensure
clearance for the rear-roller grease fitting.
3. Tighten the 2 bolts securing each
roller-brush-bearing housing to the roller-brush
mounting brackets.
5
(Figure 9).
(Figure 10).
Figure 10
5. Light contact
6. Rear roller
7. Grease fitting
g027303