Toro Reelmaster 03657 Installation Instructions Manual page 13

Restraining the Reel for Installing
Threaded Inserts
1. Insert a long-handled pry bar (recommended
3/8" x 12" with screwdriver handle) through the
front of the cutting reel, closest to the side of the
cutting unit that you will be torquing
2. Place the pry bar against the weld side of the
internal cutting reel reinforcement
Note:
The pry bar should contact a blade at the
front, the reel shaft, and a blade at the back of
the back of the reel, locking it in place.
Important:
Do not contact the cutting edge
of any blades with the pry bar; this may
damage the cutting edge and/or cause a high
blade.
Important:
The insert on the left side of
the cutting unit has left-hand threads. The
insert on the right side of the cutting unit has
right-hand threads.
Figure 29
1. Threaded insert for
installation
2. Reel shaft
3. Rest the handle of the pry bar against the roller
4. Per the insert's installation instructions and
torque requirements, complete the installation of
the threaded insert while ensuring that the pry
bar stays in place, then remove the pry bar.
(Figure 29).
(Figure 29).
g280384
3. Weld side of support plate
4. Pry bar
13