Table of Contents
Advertisement
between the roller-brush mounting brackets
and the side-plate mounting flanges. Save
the additional 6 mm (1/4 inch) spacers for
potential later use.
3.
Loosely secure the brush-assembly mounting
brackets to the cutting-unit side plates with the
previously removed nuts.
4.
Slide each excluder seal outward until the lip
seals are in light contact with each bearing
housing
(Figure
6).
Figure 6
1. Bearing housing
g033201
2. Excluder seal
Installing the Roller-Brush
Housing
1.
Remove and discard groomer drive cap.
1. Cap
2.
Install the left or right roller-brush housing
(Figure
8).
Note:
Ensure that the idler-pulley assembly is
installed on the bottom as shown in
1. Roller-brush housing
2. Retaining ring
3.
Apply 242 Loctite (blue) to the 2 bolts (5/16 x
1/2 inch) and use them to mount the roller-brush
housing to the bearing housing
Note:
Torque the bolts to 20 to 26 N∙m (15 to
19 ft-lb).
4.
Secure the roller-brush housing to the
groomer-drive housing with the retaining ring
(Figure
8).
5.
Ensure that the roller-brush housing is parallel to
the cutting-unit side plate. Proceed as follows:
4
Figure 7
Figure
Figure 8
3. Bolt (2)
4. Bearing housing
(Figure
8).
g283858
8.
g033300
Advertisement
Table of Contents
