Compressed Air Connection - Nederman FilterMax F Series Instruction Manual

Connect the compressed air supply line
to the compressed air connection of
the filter. Use pipe sealant on all
compressed air connections.
Compressed air components
(accessories, see page. 30)
A shut off valve for service work and a
filter regulator should be installed in the
compressed air pipe line (Note the flow
direction during the installation).
Important! the filter regulator
must be positioned in a frost free
environment.
Recommended connection size:
minimum 1/2".
FilterMax F
Control box
Service valve with
integrated drain valve
(accessory)

COMPRESSED AIR CONNECTION

Pressure switch
(accessory)
Filter regulator,
recommended pressure
0,5 MPa (5 bar / 73 psi)
(accessory)
Compressed air tank, module no. 3
Compressed air tank, module no. 2
Compressed air tank, module no. 1
IMPORTANT!
• The compressed air supply pressure has
to be = 0,4 - 0,6 MPa (4 - 6 bar / 58 - 87 psi).
• The compressed air shall have a dew point
below the minimum temperature at which the
system is ment to be used.
• The compressed air supply must be both oil
and water free.
• Improper air pressure or contamination in
the compressed air can result in cleaning
valve failure, poor cleaning and filter
performance.
• Purge compressed air lines to remove debris
before connecting to the compressed air
manifold.
• Do not use thread-sealing tape after the
filter regulator.
• Quick couplings throttle the air too much
and are not recommended.
• Turn off and bleed off compressed air supply
before doing any service work.
• Do not pressurise the system if the air tem-
perature is below the minimum operating
Compressed
temperature, that is -20 °C. At lower air tem-
air connection
perature the process could be started and be
in operation for a while (approx. 15 min.) after
which the system can be pressurised.
Water drain valve
Water drain valve
Water drain valve
8