Mounting The Filter Cartridges - Nederman FilterMax F Series Instruction Manual

NB! The inlet and outlet are reversable
and concequently they can be positioned
for duct connection on the
right or left side of

MOUNTING THE FILTER CARTRIDGES

1.
Unscrew the two fixing screws on the
access door. Use the enclosed T-key or a 10 mm
standard hexagon key. Open the door.
3.
Handle the filter cartridges carefully to
avoid mechanical damage to the filter surface.
the filter.
2.
Loosen the nuts
on the filter holders
but don't screw them
off completely.
Remove the filter
holders.
4.
Insert the filter
cartridges. NB! The
mark on the back end
cap should be put on
the angled sheet-metal
plate just inside the
filter hole.
4.
Fit the inlet and outlet.
(NB! The inlet is equipped with
an inspection cover on top.)
WARNING!
Risk of personal injury!
For FilterMax F equipped with 2 or 3 modules
(12 or 18 filter cartridges), an approved lifting
platform (see figure) has to be used when
mounting or replacing the filter cartridges.
5.
Hang the filter holders on the screws
and fasten the nuts.
6.
Shut the access door and
fasten the two fixing screws.
7