Nederman FilterMax F Series Instruction Manual page 10

ACTIVATING THE MENU
Push the P-button and the 0/1-button more than 4 seconds.
ACTIVATING INPUTS AND OUTPUTS
The inputs or outputs should be activated when accessories
have been connected. Push the P-button to activate actual
input/output. The LED's indicate, where appropriate, with
red blinking lights.
The inputs are activated in the following order:
Selecting OFF, nC or nO
Push the 0/1-button and OFF, nC or nO comes up on the display.
OFF The selected input is not activated.
nC Normally closed: The selected input is activated.
nO Normally opened: The selected input is activated.
Select NC or NO depending on type of contact on the connected
accessory. Make a note of the setting which has been selected.
or nC or nO
A
OFF
Red blinking
or nC or nO
B
OFF
Red blinking
or nC or nO
C
OFF
Red blinking
or nC or nO
D
OFF
0
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1
Red blinking
Motor protector, fan
Push the P-button.
Activated input: JP1: 6
Set OFF, nC or nO with the 0/1-button.
OFF nC nO
High dust level indicator
Push the P-button.
Activated input: JP1: 3
Set OFF, nC or nO with the 0/1-button.
OFF nC nO
Pressure switch, compressed air
Push the P-button.
Activated input: JP1: 2
Set OFF, nC or nO with the 0/1-button.
OFF nC nO
Pressure switch
high dP / low airflow
Push the P-button.
Activated input: JP1: 4
Set OFF, nC or nO with the 0/1-button.
OFF nC nO
0
1
0
1
P
10