Power Supply Wiring - Extron electronics CVEQ 100 User Manual
1-input, 1-output equalizing composite video and s-video line drivers
Hide thumbs
Also See for CVEQ 100:
- Specifications (4 pages) ,
- Specification (4 pages) ,
- Brochure & specs (3 pages)
Table of Contents
Advertisement
im Vertrieb von
Installation and Operation, cont'd
Tip
(Signal)
Sleeve (Gnd)
Ü
Video output connector (CVEQ) — Connect a composite video
output device to this BNC connector.
á
S-video output connector (SVEQ) — Connect an S-video output
device to these Y and C BNC connectors.
e
Audio output connector — Cable a balanced/unbalanced audio
output device to this 3.5 mm 5-pole captive screw connector.
Wire the male connector as shown below.
Balanced Audio Output
Tip
Ring
Sleeve(s)
Tip
Ring
Power supply wiring
Wire the line driver's power connector, as shown below.
Smooth
Ridges
A
A
Power Supply
Output Cord
Power connector wiring
Power supply voltage polarity is critical. Incorrect
C
voltage polarity can damage the power supply and
the line driver. Identify the power cord negative
lead by the ridges on the side of the cord.
www.camboard.de
2-10
CVEQ 100 & SVEQ 100 • Installation and Operation
Unbalanced Audio Output
Tip
NO GROUND HERE
Sleeve(s)
Tip
NO GROUND HERE
CAUTION
Connect the sleeve to ground
(Gnd). Connecting the sleeve to
a negative (–) terminal will
damage the audio output circuits.
SECTION A–A
Tie Wrap
Orange Captive Screw
Connector
CAMBOARD Electronics
Tel. 07131 911201
Fax 07131 911203
To verify the polarity before connection, plug in the power
supply with no load and check the output with a voltmeter.
W
The two power cord wires must be kept separate
while the power supply is plugged in. Remove
power before wiring.
C
The length of the exposed (stripped) copper wires
is important. The ideal length is 5/16" (7 mm).
Longer bare wires can short together. Shorter wires
are not as secure in the direct insertion connectors
and could be pulled out.
Use the supplied tie-wrap to strap the power cord to the
extended tail of the connector.
N
Your line driver may have shipped with a blue captive
screw connector. This blue connector can be plugged into
either a blue or an orange power receptacle.
The blue connector does not have the extended tail or the
included tie-wrap.
N
Do not tin the power supply leads before installing in
the direct insertion connector. Tinned wires are not as
secure in the connectors and could be pulled out.
ce-info@camboard.de
CVEQ 100 & SVEQ 100 • Installation and Operation
2-11
Advertisement
Table of Contents
