Manual Switch (3); Heater On Instantly; Heater Off; Display Screen (4) - Harvia C260 Manual

EN

2.3. Manual Switch (3)

2.3.1. Heater On Instantly

If you press the manual switch (3) once briefly (while
the control unit is switched on), the heater comes on
immediately for half an hour; there is a reading of 0.5
in the screen and indicator light 8 comes on (heater
on). You can increase the time the heater is on by
pressing the switch once for every half hour
required. For example, six pushes of the button will
turn the heater on for a duration of three hours. You
can select a duration of up to a maximum of twelve
hours. After the selection is made the screen
displays the amount of time left for the unit to remain
on alternately with the temperature of the sauna and
the relevant indicator lights 6 and 7 flash in
synchronised rhythm.
The programmed time left diminishes on screen
automatically at intervals of 1/10 of an hour, or every
six minutes.

2.3.2. Heater Off

If you have turned the heater on in the manner
described in 2.3.1, you can switch it off before the
programmed time has expired by pressing manual
button 3 and holding it in for two seconds. This will
turn the heater off, indicator light 8 will go out, and
"OFF" will appear in the screen.

2.4. Display Screen (4)

When the control unit is in basic mode (power on) the
screen (4) displays the word "OFF", which is the
symbol that denotes that the heater is turned off.
In function mode, when the heater has been
switched on manually,
numerically both the time left for the heater to be on
and the temperature of the sauna room alternately at
intervals of a few seconds.
The numerals in the screen will show only the
temperature in the sauna room if the heater has been
switched on by means of the weekly timer program
or by remote control.

2.5. Temperature Regulator (5)

The desired sauna temperature is set by means of the
temperature regulator (5) in the screen (4). By
turning it clockwise you increase the temperature,
and by turning it anti-clockwise you lower it. When
the regulator is turned to the left or right the set
temperature automatically becomes visible in the
screen and indicator light 6 flashes.
The maximum temperature you can set is 110°C.

2.6. Indicator Light, Red (6)

When indicator light 6 is on continuously, the display
shows the temperature of the sauna. If the system
has had to be switched on manually, the red and the
green indicator lights come on alternately. When the
red light is on the screen displays the temperature and
when the green light is on the time left for the heater
to be on is shown.
When the temperature is being set using the
regulator (5) the indicator light flashes rapidly.
10
the screen displays
CZ
2.3. Manualni owladani (3)
2.3.1. Okamzite sepnuti kamen
Kdyz stisknete kratce tlacitko manualniho ovladani (3 )
( kdyz je jednotka zapnuta hlavnim vypinacem )
kamna zacnou topit na pul hodiny
a na displeji se zobrazi 0,5 hodiny
a bude svitit kontrolka 8.
Vícenásobnym stisknutim si budete
zvysovat doba, po kterou kamna
budou topit. Napr. 6x zmacknuti
je 3 hodiny. Maximálni doba je 12 hodin
Po vyberu se zacne odpocitavat cas
a kontrolky 6 a 7 budou blikat, dokud
se nesynchronizuji.
Zbyvajici cas se vzdy aktualizuje po
6 minutach.
2.3.2. Vypnuti kamen
Kdyz jste kamna sepli manualne dle
podle popisu 2.3.1. muzete kamna i manualne
predcasne vypnout. Kamna vypnete tim
, ze podrzite tlacitko (3) po dobu 2 sekund.
Tim se kamna vypnou, vypne kontrolka 8
a na displeji zmizi napis OFF.
2.4. Displej (4)
Kdyz je ovladaci jednotka v zakladnim rezimu
na displeji sviti napis OFF, který ale naoznacuje
ze jsou kamna vypnuty.
Kdyz kamna sepnete manualne, na displeji se
zobrazi v radu nekolika sekund zobrazi teplota a
nastaveny cas.
Cislice na displeji s teplotou v saune
se zobrazi pouze tehdy pokud
budou kamna sepnuty tydennim casovacem
nebo dalkovym ovladanim

2.5. Regulace teploty (5)

Nastaveni teploty v saune provadite pomoci
ovladace (5) na displeji (4).
Zmenu teploty provadite otacenim doleva a doprava.
Pri nastavovani zelena kontrolka rychleji blika.
Maximalni teplota ktera lze nastavit je 110 C.
2.6. Kontrolky cerwena (6)
Kdyz kontrolka 6 trvale sviti.
Displej zobrazuje teplotu v saune.
Kdyz sepnete kamna manualne,
cervena a zelena kontrolka budou
blikat stridave.
Cervena kontrolka sviti u teploty
a zelena zobrazuje odpocitavajici se cas.
Kdyz se nastavuje teplota regulatorem (5)
zelena kontrolka zacne rychleji blikat.