Oil Change In Tamper Foot - Bomag BT 60/4 Operating Instructions, Maintenance Instructions

Attach the screw M6x16 (6) with washer (5)
l
and bracket for engine guard plate to the recoil
starter.
Attach the screw M6x8 (4) to the recoil starter.
l
Tighten screws (1), (4) and (6).
l
BT 60/4, BT 65/4

6.17 Oil change in tamper foot

Caution
!
Ensure strict cleanliness.
Change the oil at operating temperature.
For quality and quantity of oil refer to the "table
of fuels and lubricants".
Environment
Catch running out old oil, do not let it seep into
the ground and dispose off environmentally.
Tip the tamper backwards.
l
Fig. 68
Clean and unscrew the oil drain plug (Fig. 68),
l
let the old oil run out and catch it.
Check the seal on the drain plug, replace if
l
necessary.
Turn the drain plug in and tighten it.
l
BOMAG
Maintenance every year
53