Adjusting The Steering Bow; Starting The Engine - Bomag BT 60/4 Operating Instructions, Maintenance Instructions

5.3 Adjusting the steering bow

1
4
Fig. 11
i Note
The steering bow has three positions.
The steering bow can be adjusted to the height of
the operator by using the bore holes (2), (3) and
(4) (Fig. 11):
(2) lowest position
(3) middle position
(4) highest position
Loosen the screws (1) on both sides
l
Loosen the screws (4) on both sides and pull
l
them out.
Set the steering bow to the desired height.
l
Tighten screws (1) and (4) on both sides.
l
BT 60/4, BT 65/4
2
3
540080
BOMAG
5.4

Starting the engine

Danger
!
Exhaust gases are extremely dangerous!
Always ensure an adequate supply of fresh air
when starting and operating in closed rooms
and trenches!
Danger
!
Danger of accident!
Examine the starter rope of the recoil starter
for chafing before starting, replace if neces-
sary. A damaged rope can break and cause in-
juries during starting.
Always hold on to the machine.
Keep your feet away from the tamper plate, be-
cause the vibration starts immediately.
Always keep an eye on a running machine.
Danger
!
Loss of hearing!
Wear your personal noise protection means
(ear defenders) before starting operation.
Fig. 12
Open the fuel cock(Fig. 12).
l
Operation
25