Fronius Selectiva 4185 Operating Instructions Manual page 22

(10)
(11)
* The CAN connection area can only be accessed by removing the connection plate on
Danger from electric current.
This can result in serious injury or death.
► Only trained service technicians may open the housing. This includes removing the
► The device must be disconnected from the mains before starting any work with the
► A suitable measuring instrument must be used to ensure that electrically charged com-
► Use an easily legible and understandable warning sign to ensure that the device is not
Danger due to work that has been carried out improperly.
This may result in serious injury and damage to property.
► Connection work on the device must only be carried out by qualified specialist techni-
► If there are Installation Instructions or User Information for the optional component con-
► Once the connection work is complete, a safety inspection must be carried out in ac-
► Further details on safety inspections can be obtained from your authorised service cen-
► They will provide you with any documents you may require on request.
The figure shows the connections in the
CAN connection area.
The CAN connection area is located be-
hind the connection plate on the front of
the device. The warning notices listed
above apply to the CAN connection area.
(2) External start/stop (+) - black
(3) External start/stop (-) - black
(5) Detect - white
(6) CAN High - green
(7) CAN Low - yellow
(8) CAN GND - brown
22
Control panel
Optional LED strip
Lights up in different colours depending on the state of charge, as explained in the
"Control panel" section
the front of the device. The following warning notices must be obeyed:
WARNING!
connection plate.
housing open.
ponents (e.g. capacitors) are fully discharged.
reconnected to the mains supply before all the work has been completed.
WARNING!
cians.
cerned, then all warning notices and instructions therein must be obeyed.
cordance with relevant national and international standards and directives.
tre.
Ext. Start/Stop (+) (2)
black
Ext. Start/Stop (-) (3)
black
Detect
(5)
white
CAN High (6)
green
CAN Low (7)
yellow
CAN GND (8)
brown
42,0409,0411