Subscribe to Our Youtube Channel
Related Manuals for CHIEF Small Flat Panel In-Wall Swing Arm Mount FWDIW-I Series
Summary of Contents for CHIEF Small Flat Panel In-Wall Swing Arm Mount FWDIW-I Series
- Page 1 I N S T A L L A T I O N I N S T R U C T I O N S Small Flat Panel In-Wall Swing Arm Mount FWDIW Series...
- Page 2 FWDIW Series DISCLAIMER Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product.
- Page 3 Installation Instructions TOOLS REQUIRED FOR INSTALLATION AND PARTS C (4) 5/16-18 x 5/8" G (2) L (12) Q1 (4) M4x8mm M4x16mm 3/16" (Included) A (1) D (4) 5/16" H (2) N (1) M (4) 3/16" Q4 (1) Q2 (6) Q3 (6) 1/8"...
- Page 4 FWDIW Series Installation The following procedure assumes that a Chief Model FAC501 In-Wall accessory has previously been installed following the installation instructions provided by the manufaurer. If a FAC501 is not installed or there are any other questions regarding the installation of this accessory, immediately contact Chief.
- Page 5 Installation Instructions Display Installation The mounting holes on the back of the display will either be flush with the back surface, or recessed into the back surface. Refer to the applicable installation procedure below. Flush Mount Display WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Using screws of improper size may damage your display! Proper screws will...
-
Page 6: Cable Management
FWDIW Series Attach Interface Bracket to Display Lay display face down on a clean and dry flat surface. Attach Interface Bracket (Q4) to display using six M4x16mm Phillips flat machine screws (Q2) and six 1/8" spacers (Q3). (See Figure 7) Tighten all screws. - Page 7 Installation Instructions Trim Installation To install optional trim; Remove paper covering adhesive and affix three tape squares (L) to inside lower flange of each trim piece (B). (See Figure 11) Orient trim pieces (B) as shown in figure below. (See Figure 11) Remove paper covering adhesive back from tape squares (L) on trim and press trim (B) against inner wall of box.
- Page 8 FWDIW Series Chief Manufacturing, a division of Milestone AV Technologies 8805-000240 Rev B 2008 Milestone AV Technologies www.chiefmfg.com 10/08 USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands...
Need help?
Do you have a question about the Small Flat Panel In-Wall Swing Arm Mount FWDIW-I Series and is the answer not in the manual?
Questions and answers