Stm32 (Steval-Pcc012V1) And Evalst7590-1; Figure 6. Evalst7590 - Microcontroller Extension Connector; Figure 7. Evalst7590 - Jumper Setup; Figure 8. Steval-Pcc012V1 - Plm Connector Cn7 - ST STM32 User Manual

UM1038
3

STM32 (STEVAL-PCC012V1) and EVALST7590-1

The demonstration boards necessary to connect the STM32 and ST7590 boards and their
configuration:
1. STEVAL-PCC012V1
●
●
2. EVALST7590-1
●
●
●
Figure 6.
Figure 7.
Figure 8.
Flash the correct firmware into STM32.
Configure the board according to
Put the jumper into position JP12 - USB_RES (see paragraph
in Appendix C).
Configure the board according to
Interconnect EVALST7590-1 according to
EVALST7590 - microcontroller extension connector
EVALST7590 - jumper setup
STEVAL-PCC012V1 - PLM connector CN7
Doc ID 18303 Rev 1
STM32 (STEVAL-PCC012V1) and EVALST7590-1
Figure 3.
Figure 7.
Table 2
1
and Figure 9.
7/24