Mounting The Device On A Panel - NI cRIO-9066 User Manual

What to Use
• cRIO-9066
• Screwdriver, Phillips #2
• M4 or number 8 screw (x2), user-provided, longer than 23.00 mm (0.91 in.) to pass all
the way through the cRIO-9066
What to Do
Complete the following steps to mount the cRIO-9066 directly on a flat surface.
1. Prepare the surface for mounting the cRIO-9066 using the
2. Align the cRIO-9066 on the surface.
3. Fasten the cRIO-9066 to the surface using the M4 or number 8 screws appropriate for the
surface. Tighten the screws to a maximum torque of 1.3 N · m (11.5 lb · in.).
Surface Mounting Dimensions
The following figure shows the surface mounting dimensions for the cRIO-9066.
Figure 12. cRIO-9066 Surface Mounting Dimensions

Mounting the Device on a Panel

You can use the NI panel mounting kit to mount the cRIO-9066 on a panel.
18 | ni.com | NI cRIO-9066 User Manual
141.7 mm
(5.58 in.)
47.2 mm
(1.86 in.)
Surface Mounting Dimensions.
30.8 mm
(1.21 in.)
47.0 mm
(1.85 in.)
4.1 mm
(0.16 in.)