Table of Contents
Advertisement
4
1.
Use a #1 Phillips screwdriver to remove the two screws from the back of the chassis on
the front-panel side.
2.
Use the screwdriver and the two M3x20 screws to attach the adapter bracket to the
chassis.
3.
Align one of the end brackets with the mounting hole at one of the ends of the chassis.
4.
Use a #2 Phillips screwdriver to tighten the captive screw on the end bracket.
5.
Repeat steps 2 and 3 to attach the other end bracket to the other end of the chassis.
Desktop Mounting Dimensions
The following figures show the desktop mounting dimensions for the cRIO-9066.
2
3
1
3
NI cRIO-9066 User Manual | © National Instruments | 23
4
Hide quick links:
Advertisement
Table of Contents
