Uninstalling The Solution X2-Fix; Securing The Child - CYBEX SOLUTION X2-FIX User Manual

a
1
14

UNINSTALLING THE SOLUTION X2-FIX

Perform all installation steps in reverse order.
• Release the ISOFIX connectors (w) by simultaneously pulling and slinging back
the release buttons (y).
• Pull SOLUTION FIX out of the ISOFIX guides (u).
• Rotate the ISOFIX connectors by 180° to bring them to their original position.
• Pull the X-fix lever located at the bottom of the child car seat and push the X-fix
connectors into the child seat until completely hidden.
Note! Following these steps the vehicle's seat pad will be protected and the Isofix
connectors will be prevented from being stained or damaged. Damages and stains
2
could obstruct a smooth operation.

SECURING THE CHILD

Place the child seat on the respective seat in the car.
• Please make sure that the backrest (a) of the child safety seat rests flat against
the backrest of the car seat so that the child seat is under no circumstances in a
sleeping position.
•
backrest of the Solution X2-fix is perfectly aligned and in full contact with the
rear vehicle seat. The position can be adjusted with the adjustment lever (v)
located on the bottom of the child car seat.
• If the headrest of the vehicle is in the way, pull it out all the way or remove it
completely (for exceptions to this, please refer to the section "POSITIONING THE
SEAT CORRECTLY IN THE VEHICLE") The backrest (a) will perfectly adapt to
practically any recline of the vehicle seat.
Warning! The backrest of the Solution X2-fix should rest flat against the
upright part of the car seat. Pushing the booster rearwards the seat should be
tightly pressed against the seat. For the best possible protection of your child,
the seat must be in a normal upright position!
Note! It is possible that some car seats that are made of soft material (e.g. velours,
leather, etc.) may show signs of usage and/or discolouration. In order to avoid this,
you could, for example, place a cover or towel underneath it. In this context, we
would also like to refer to you to our cleaning instructions, which must absolutely be
followed before the first use of the seat.
When using the ISOFIX-anchorages in the car, make sure that the