Extended Mounting Arm Installation Procedures; Materials; Mounting Arm Overview; Alternative Mounting Locations - Lytx SF Series Installation Instructions Manual

Extended Mounting Arm Installation Procedures

The optional Extended Mounting Arm ("Mounting Arm") provides greater flexibility for device
placement when windshield mounting is not available/possible. The Mounting Arm allows you
to install the device on the dashboard, the ceiling, or the bulkhead.
However, the Mounting Arm is less stable than either the Standard Mounting Bracket or the
Overhead Mounting Bracket. The Mounting Arm should therefore only be installed if neither
the Standard Mounting Bracket nor the Overhead Mounting Bracket are feasible options for
installation.

Materials

Provided: Extended Mounting Arm
NOT provided:
Four (4) #10 screws (Screw length may vary by vehicle but must be long enough to
l
ensure a secure mount.)
Screwdriver
l
T-27 security Torx bit
l
Zip-ties
l
Pen OR pencil
l

Mounting Arm Overview

The Mounting Arm may be mounted in a variety of locations
due to its versatile design comprised of rotating bracket
casing and pivoting balls and sockets.
1. Rotating bracket casing
2. Pivoting balls and sockets
3. Torx adjustment screws
4. Cap and device attachment screw
5. Base (detachable)

Alternative Mounting Locations

The following are alternative mounting locations for the Mounting Arm. Please select the
best location based on the particular vehicle and the mounting location guidelines set forth
in the section, "Review Mounting Location Guidelines" on
©2019 Lytx, Inc. - Confidential & Proprietary.
page 16.
Page 38 of 51
(North America Edition)