Initiate Diagnostic Mode - Lytx SF Series Installation Instructions Manual

Initiate Diagnostic Mode

To initiate the Diagnostic Mode on the SF-Series device, you must first reboot the device. To
reboot the SF-Series device, follow these steps:
1. Press and hold either of the blue manual record buttons
on the device until the 3 center LED status lights turn blue
(hold for about 30 seconds). After they light up, let go of
the button.
2. Immediately press and hold the manual record button
again for up to 45 more seconds until all 7 LED status
lights turn blue. After they light up, let go of the button.
At this point, the SF-Series will begin rebooting.
LED Status Light Sequence: Reboot
1. As the device shuts down, all LED status lights will shut
off.
2. As it starts back up, the center LED status light will turn
green.
©2019 Lytx, Inc. - Confidential & Proprietary.
Page 46 of 51
(North America Edition)