Route The Device Power Cable - Lytx SF Series Installation Instructions Manual

4. Using a voltmeter/multimeter, test the connections.
For turn signals, the input must cycle between 0V and 12V/24V when activated.
CAUTION: Make sure 12V/24V is only shown when the turn signals are on, NOT when
the parking brake or brakes are engaged/disengaged.

Route the Device Power Cable

WARNING: Make certain that neither the cable nor your installation activities interferes
with any airbag-related mechanisms or otherwise risks affecting airbag deployment.
Consult the vehicle manufacturer for the location of any airbag sensors and systems
and restrictions that may apply.
CAUTION: Before proceeding, you may need to remove the window and door trim to
route the cable underneath. These typically snap on and off using special clips. In
vehicles with side and curtain airbags, the clips are often one-time use and may need to
be replaced after removal. Please refer to the vehicle service manual for information.
1. Route the end of the power cable from the connection points to the device, securing
the cable at least every 30 cm/300 mm and behind panels where possible.
WARNING: Be very careful working around vehicle airbags. Please refer to the
vehicle's service manual for information.
WARNING: Route the cable in a manner that protects it from damage.
©2019 Lytx, Inc. - Confidential & Proprietary.
Page 29 of 51
(North America Edition)