Installation Instructions - Lytx SF Series Installation Instructions Manual

1. Center dashboard
2. Lower corner, driver side dashboard
3. Upper or lower corners, passenger side
Note: If the event recorder is installed in a location outside of the comfortable reach of
the seated driver, the Remote Push Button should be installed as well to allow the
driver to manually record an event.
For details on installing the Remote Push Button, refer to the section,
Button Installation Procedures" on the next
4. Center overhead (ceiling or bulkhead)
You should only use the Mounting Arm in this location if use of the Overhead Mounting
Bracket is not feasible.

Installation Instructions

WARNING: Do not extend the Mounting Arm's length beyond its intended design. This
causes instability, which may result in excessive "non-events" being recorded.
WARNING: The Mounting Arm must be oriented vertically (straight up or down) for
adequate stability.
WARNING: When selecting the mounting location, check that the mounting surface can
be safely drilled. Do not drill or screw into wires or other components behind the
mounting surface that can be damaged.
CAUTION: When selecting the mounting location, check that nothing blocks the interior-
or exterior-facing lenses. Objects such as large sun visors, window tint, and circulation
fans may block one of the lenses and should be avoided. Also check that the device does
not block the driver's line of sight in the selected mounting location.
©2019 Lytx, Inc. - Confidential & Proprietary.
page.
Page 39 of 51
(North America Edition)
"Remote Push