Run Testing And Complete Installation - Lytx SF Series Installation Instructions Manual

2. Connect the event recorder connector to the event recorder. Place the Tamper Preven-
tion Clip behind the connector and secure it using the T-8 screw. Loosen the screws to
tilt the device so installation of the locking screw is easier.
3. Make sure the cable is clear of any sharp edges, moving parts, and cannot get pinched
in the door jamb.
4. Make sure the cable is tucked away and secured so that it cannot come loose. Lytx
recommends using cable-ties at least every foot, or as necessary, along the route of
the cable to secure it in place.

Run Testing and Complete Installation

Testing is important to make sure the device is connected to the vehicle systems properly
and that no active faults exist in the vehicle system.
Completion of the installation consists of these subsections:
Test Event Creation and Upload
Test Wire Connections and Settings in the Lytx Installation Tool
Camera Measurements (ER-SF300 devices only)
Initiate Diagnostic Mode
Complete Installation
Conduct Final Checks
©2019 Lytx, Inc. - Confidential & Proprietary.
31
31
32
33
34
34
Page 30 of 51
(North America Edition)