Complete Installation; Conduct Final Checks - Lytx SF Series Installation Instructions Manual

Event recorder
Hide thumbs Also See for SF Series:
Table of Contents

Advertisement

4. After 4 minutes, the device exits Diagnostic Mode. Verify the center LED light turns
green.
Troubleshooting in Diagnostic Mode
If you run into any issues in Diagnostic Mode, take the troubleshooting steps in
"Troubleshooting in Diagnostic Mode" on page 47.
If issues persist after troubleshooting, please contact the Lytx Technical Support Center
at 925.732.4246 or email support@lytx.com.

Complete Installation

1. Finalize all electrical connections. Use cable-ties to bundle and secure all wires.
2. Replace any trim pieces on the door pillar and dash that were removed.
3. Make sure the cable is routed safely and cannot get pinched in any moving parts.
4. Reaffirm you have taken the appropriate safety precautions while working around
vehicle airbags.
5. Keep this guide in a safe place for future use.

Conduct Final Checks

After installation of the SF-Series device but prior to any operation of the vehicle, check all
vehicle system lights, signals, and any other devices (such as electronic log devices systems
or CB radios) to make sure they are working properly.
Minimum checks should include the following (consult the vehicle manufacturer's service
manual for additional checks that must occur):
1. Constant power: Ensure the event recorder is powered when the ignition is off
(12V/24V to red wire).
2. Switched power: Confirm 12V/24V to the brown wire when the ignition is on.
3. Ground: Ensure the black wire is connected to a solid grounding point in the vehicle
with no paint or rust.
4. Event creation: Turn the vehicle on and press either
blue button on the event recorder. Confirm an event is
created by verifying the LED's light up green from left
to right, one by one.
5. Manually upload events to Lytx:
a. Press and hold one of the blue buttons on the device. The center LED light starts
green, disappears, and then re-appears green. Let go when it re-appears.
b. If upload is successful, all LED status lights will light up one-by-one from left to
right, each light going from blinking to solid green.
©2019 Lytx, Inc. - Confidential & Proprietary.
Page 34 of 51
(North America Edition)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Er-sf64Er-sf1Er-sf300

Table of Contents