Sf-Series Installation Procedures; Mount The Bracket And Event Recorder - Lytx SF Series Installation Instructions Manual

SF-Series Installation Procedures

Installation of the SF-Series event recorder consists of these main sections. Each section
has its own subsections as well:

Mount the Bracket and Event Recorder

Connect Electrical Wiring
Run Testing and Complete Installation
Pre-Installation Check
Before beginning the installation, turn the vehicle on. Verify that no Check Engine lights,
error codes, or warnings appear on the gauge console, dashboard, or vehicle display. It
may be necessary to cycle through displayed messages or screens to verify.
If any Check Engine lights, error codes, or warnings appear, report these to the site
contact before proceeding.
Mount the Bracket and Event Recorder
WARNING: Before mounting the bracket and event recorder, consult the vehicle
manufacturer's recommendations and any applicable federal, state, provincial and local
laws that restrict mounting devices on a vehicle's windshield or other locations in a
vehicle.
Mounting the bracket and event recorder consists of these subsections:
1. Review Mounting Location Guidelines
a. Mounting Location Recommendations and Restrictions
2. Prepare the Mounting Location
3. Attach the Bracket and Event Recorder
Alternative Mounting Methods
The subsections, "Prepare the Mounting Location" on page 18 and "Attach the Bracket
and Event Recorder" on page 19, cover the recommended standard windshield mounting
method only. However, if windshield mounting is not possible/permitted in the vehicle
or jurisdiction, alternative mounting methods are available. For instructions on altern-
ative mounting methods, please review the mounting location guidelines and see "Install-
ation of Optional Parts" on page 36.
©2019 Lytx, Inc. - Confidential & Proprietary.
15
19
30
Page 15 of 51
(North America Edition)