Table of Contents
Advertisement
ER-SF1 Event Recorder with J1939 Network Instructions for Self Installation
6. Make sure the cable is tucked away and secured so that it cannot come loose. We
recommend using cable-ties every few inches along the route of the cable to secure it in
place.
Run Testing and Complete Installation
Boot Up the ER and Test Event Creation
1. Key the ignition to ON and plug the Vehicle Interconnect Cable to the Standard Power
Cable.
2. Observe the event recorder. The center LED status lights should turn green, then turn off.
The LED status lights then light up from left to right twice, indicating the device is booting
up. The center LED status light will then go to solid green.
3. Press either blue button on the unit to create a manual event. The LED status lights will
light up green one by one from left to right until all are lit (lasts ~10 seconds). Confirm this
light pattern.
Test Wire Connections and Settings in the Lytx Installation Tool
1. Connect a Windows laptop running the Lytx Installation Tool program to the ER-SF1 with
the USB cable.
a. Note: You may use a USB extension cable up to 3 feet in length.
2. Refer to the Lytx Installation Tool Guide for instructions on how to finalize the installation.
Ignition and the vehicle J1939 connection (via engine RPM) can be verified via the Lytx
Installation Tool.
Complete Installation
The ER-SF1 event recorder is installed and ready to use.
© 2017 Lytx, Inc. – Confidential & Proprietary – For Velociti's Use Only Re Beta ER-SF1 Installations. Page 23 of 26
Hide quick links:
Advertisement
Table of Contents
