Route The Er Cable - Lytx ER-SF1 Installation Instructions Manual

ER-SF1 Event Recorder with J1939 Network Instructions for Self Installation
Refer to the Electrical Connection Overview Diagram above for the following steps.
1. Connect the CAN Coupler to the Standard Power Cable.
2. Find a suitable location along the vehicle J1939 network backbone to insert the CAN
Coupler. The CAN Coupler
moisture or inclement weather conditions.
3. Untwist approximately 2 inches of the vehicle's J1939 wires, which are always a green and
yellow twisted pair.
4. Insert the vehicle's J1939 wires into the CAN Coupler with the yellow wire on the CAN-HI (Y)
side and the green wire on the CAN-LO (G) side. Ensure that the wires are secured in the
tabs provided and properly oriented.
5. Place the cap on the CAN Coupler.

Route the ER Cable

WARNING: WHEN INSTALLING THE CABLE IN A VEHICLE WITH SIDE OR CURTAIN
AIRBAGS, BE CERTAIN THAT NEITHER THE CABLE NOR YOUR INSTALLATION ACTIVITIES
INTERFERES WITH ANY AIRBAG-RELATED MECHANISMS OR OTHERWISE RISKS AFFECTING
AIRBAG DEPLOYMENT.
Note: You may need to remove the window and door trim to route the cable underneath. These
typically snap on and off using special clips. In vehicles with side and curtain airbags, the clips are
often one-time use and may need to be replaced after removal. Please refer to the vehicle service
manual for information.
1. Route the end of the ER cable from the adapter to the nearest door pillar. Route the cable
behind and underneath the dash until reaching the kick panel.
2. Starting from below the dash near the kick panel, route the end of the ER cable up the door
pillar underneath the vertical door/window trim to the top of the door pillar.
3. Route the ER cable across the top of the windshield under the window trim or headliner to
the ER device (see below).
© 2017 Lytx, Inc. – Confidential & Proprietary – For Velociti's Use Only Re Beta ER-SF1 Installations. Page 21 of 26
MUST be installed in the vehicle cab. It cannot be exposed to