Siemens SIMOTICS L-1FN3 Configuration Manual page 577

Power connection
Table 10- 2
Minimum distances between master and stoker
NOTICE
Phases V and W interchanged
Minimum distance M between the master and stoker when phases V and W are
interchanged is stated in the table above.
If a different minimum distance M is required, you must interchange other phases.
• In this case, contact your local Siemens office or "Technical Support". You will find
Note
Design differences between peak and continuous load motors
The design differences between peak and continuous load motors result in different
distances between housings D and minimum distances M.
1FN3 linear motors
Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
Power connection in a Janus arrangement of two primary sections
Motor Module
U2
V2
W2
contact data in Chapter "Introduction".
Master
U
V
W
Coupled motors
10.2 Master and stoker
Stoker
U
W
V
575