Jaw Range; Jaw Change - SCHUNK KSC-F 80 Installation And Operating Instructions Manual

_________________________________________________________________________________________

4.2 Jaw range

The reliable function of the clamping device is significantly affected by the selection of the
correct system jaws.
For further data, please see the current catalogue >> Schunk stationary Workholding <<

4.3 Jaw change

System jaws must be attached using cylinder screws with strength class 12.9:
KSC-F 80 each 2x M10 cylinder screws, clamping torque 60 Nm.
KSC-F 125 each 4x M10 cylinder screws, clamping torque 60 Nm.
KSC-F 160 each 4x M16 cylinder screws, clamping torque 140 Nm.
(Figure: KSC-F 125)
schunk.com XND.00030.002_B – 10/2018 30